I actually did some of this yesterday, but didn't take pictures of it. I cut pieces of PVC molding and applied them to the ribs of the vaulting, given them some dimension. I then used epoxy and Milliput to attach the roof to the plastic strips I'd made earlier (protecting the layer below them with tape). After letting it dry (I am updating this blog post the next day) I was able to remove the roof without too much difficulty and fit it to the sockets fairly easily. I think I will widen the holes a little and cut down the pins slightly, but the general idea works!
=][= Danforth Laertes
No comments:
Post a Comment